#MPLAB ICD 3 USB DRIVER CODE#
Change PicKit 3 back to ICD 3 and load the debugging code again. In desperation, I switched to PicKit 3 and found that the debugging code can be loaded smoothly.ħ.
#MPLAB ICD 3 USB DRIVER INSTALL#
Restart the PC, install MaplabX 1.80, open the original project file after installation plug in the ICD3 USB cable, the system will automatically install the driver Debug -> Debug Project again, and see that the problem still exists.Ħ. See that MaplabX 1.80 can be downloaded from the Microchip website. Use uninstall 6.2.0 to uninstall MaplabX 1.70, be sure to uninstall it cleanly. Use the ICD 3 test interface module of ICD3 to check whether ICD3 is out of order and find that everything is functioning normally.Ĥ. MPLAB ICE 2000 with USB converter MPLAB ICD 2 (P/N 10-00397) MPLAB ICD 3.
Try again, and the problem still exists.ģ. MPLAB IDE USB Device Driver First Time Installation For Windows 7 64 OS To. Plug and unplug the USB cable again to ensure that there is no short circuit or other abnormalities in the target board. Select MPLAB ICD 3 on either the Debugger or Programmer menu in MPLAB IDE. Connect the ICD 3 Test Interface Board to the debugger using the modular cable. Disconnect the debugger from the target and PC.
Uninstall the driver of ICD 3 through the manager, and let MaplabX 1.70 install the driver by itself again, the problem still exists after finishing.Ģ. Use the ICD 3 Test Interface Board to verify that the MPLAB ICD 3 is functioning properly: 1. The premise is that ICD 3 has been used to load the program on the same target board for debugging.ġ. User program finishedAmong them, JIT110837830 is the model of ICD 3. Could not acquire hardware tool communications resources: ICD3PlatformTool SN#JIT110837830
0 kommentar(er)
